I can close it without delay, and if I disconnect the Docking station it immediately connects. It says "Connecting to virtual disk service." But it never does. Side note: Disk Manager is now refusing to load up whenever I have the docking station connected. Think I could just "throw money at it", buy a high end drive and eliminate the issue altogether? I received this Docker as a gift and have been thinking about upgrading anyways. My drives were formatted as NTFS, I believe. Hope this helped? If not please let me now. Thermaltake BlacX Duet 2.5”/3.5” SATA I/II/III USB 3.0 External Hard Drive Enclosure Docking Station ST0014U-D The same company has a 3.0usb duel drive that transfers up to 5gbs & the price is small (under$60.00) & could save you a lot of time & is plug & play. You are using the esata/usb2.0 with a max of about 450mbs +. If you know what your file formats are on your drives?Īll that being said & reading your other comments about your dock & time consumption transferring files.Īlso not to just suggest you throw money at it. So it could be your issue, & no conflicts on other computers. Ok Windows10 64 likes to setup gbt file format on hdd it does conflict with mbr drives. I'll make note of your suggestion in case there's another transfer marathon in my future. I was actually afraid that running multiple transfers might have been slowing down the overall process rather than helping, but after doing it for hours on end I got really tired of starting transfers. If you have a good reference for doing so, I'd owe you another one. I'm going to do a websearch after I send this. I'm currently far from home and only have access to my laptops.Ĭan't say I know how to directly connect them to SATA driver. Thermaltake BlacX Duet eSATA USB Dual Hard Drives Docking Station ST0014U I'm not very experienced with the technical side of things. I'm confused and not sure how to get these two working together again. My primary laptop is still able to use other devices perfectly fine in all usb ports. I can still use the docker on other devices. But it's still terribly slow if I try to run anything off of them, and they always go back to being completely inaccessible within half an hour. In that case, they'll flicker in and out of detection, and after a minute or two I'll be able to access them. A couple hundred gb each.Īnd now I find myself unable to access the docker drives I've recieved a couple errors every now and again whenever I plug them in, but for the most part they just won't be detected at all. I was pretty impatient about it, usually had 4+ transfers running at once. Probably 10 tb worth of transfer overall. However, I spent 3 days transferring files around, from my pc to the drives, from the drives to the pc, from one drive to another. I switch out my hdds a lot, but I've always been careful when doing so. I have a a dual docker that I've used for the past two years.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |